*This message was transferred with a trial version of CommuniGate(tm) Pro*
Hi
I was just on the Shotgun News site and came across several ads for what you want for 100 bucks.
Glenn
Glenn wrote:
> Rivets for making display 1919's were available from Sarco. It seems that no matter where you pick up a dummy side plate the whole project runs about $600 when your done(if its a nice job) including the non-gun parts set.
> Glenn
>
> LEEnCALIF@aol.com wrote:
>
> > *This message was transferred with a trial version of CommuniGate(tm) Pro*
> > What works best to remove cosmolene on weapons? Gasoline???
> >
> > Does anyone know where I could get a rivet pack for the Browning 1919A4 or
> > the demilled right side plate? The ones I've found in shotgun news run about
> > $225 for the 80% types. Must something cheaper. Decided not to try to make
> > it semi-auto, just too many people would freak out! lol
> >
> > Somebody recently sent me some info. on an aluminum right side plate, but
> > during my recent hard drive crash, I lost all my notes! Sorry.
> >
> > Thanks in advance...
> >
> > Jack
> >
> > PS What the heck is cosmolene anyway?? I know what it does, just not sure
> > what it is.
> >
> > ===Mil-Veh is a member-supported mailing list===
> > To unsubscribe, send e-mail to: <mil-veh-off@uller.skylee.com>
> > To switch to the DIGEST mode, send e-mail to <mil-veh-digest@uller.skylee.com>
> > Send administrative queries to <mil-veh-request@uller.skylee.com>
This archive was generated by hypermail 2b29 : Tue Apr 04 2000 - 21:57:16 PDT