*This message was transferred with a trial version of CommuniGate(tm) Pro*
Hi Jon and Gavin,
I bought the adaptor set from Trader John's Outpost in Elgin Illinois for $25. They are a link from the MVPA suppliers page. I still have their address around here somewhere.
Jim
Jim Winne MVPA #17216
1967 M-715 Kaiser Jeep Cargo Truck
1983 M-101A1 USMC cargo trailer
My amateur radio callsign KB4IVH
-----Original Message-----
From: jonathon [SMTP:jemery@execpc.com]
Sent: Tuesday, May 09, 2000 9:28 AM
To: mil-veh@uller.skylee.com
Subject: Re: [MV] Distributor adapter wanted.
*This message was transferred with a trial version of CommuniGate(tm) Pro*
>The mil TMs for the Mutt (and no doubt others) refer copiously to the
>"screw-in adapter" for the coil negative terminal.
>
>I would appreciate any leads on one, with a cost preferably.
I assume your talking about the adapter set thats used with the large test
box??? The Levy-Latham store at Great Lakes IL has a pallet full of the
tester boxes and scattered thruout that same row are the small boxes with
all the adapters in them. Try putting in a bid, if you don't get it, go a
little higher until you do. They have a web-site for this stuff also,
probably www.levy-latham.com but I'd have to verify.
je
===Mil-Veh is a member-supported mailing list===
To unsubscribe, send e-mail to: <mil-veh-off@uller.skylee.com>
To switch to the DIGEST mode, send e-mail to <mil-veh-digest@uller.skylee.com>
To reach a human, contact <help@uller.skylee.com>
This archive was generated by hypermail 2b29 : Thu Jun 01 2000 - 22:37:11 PDT