Re: [MV] CARC stripper

From: Jason E. Rose (m151a1@micron.net)
Date: Fri May 26 2000 - 13:06:39 PDT

Next message: Jason E. Rose: "Re: [MV] Alternater"
Previous message: Richard Faunce: "Alternater"
Next in thread: Brandon: "Re: [MV] CARC stripper"
Maybe reply: Brandon: "Re: [MV] CARC stripper"
Maybe reply: Everett Doyle: "Re: [MV] CARC stripper"
Maybe reply: jonathon: "Re: [MV] CARC stripper"
Maybe reply: Mel Miller: "Re: [MV] CARC stripper"
Maybe reply: jonathon: "Re: [MV] CARC stripper"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

*This message was transferred with a trial version of CommuniGate(tm) Pro*
As a matter of fact, last night I was using oven cleaner on my mutt. It
works pretty well.

Jason
----- Original Message -----
From: Glenn <dogstar918@mediaone.net>
To: <mil-veh@uller.skylee.com>
Sent: Friday, May 26, 2000 12:51 PM
Subject: [MV] CARC stripper

> *This message was transferred with a trial version of CommuniGate(tm) Pro*
> Has anyone got any preferences on chemical stripper for use on small
> aluminum panels that are painted with CARC. I would prefer stripper
rather
> than sandblasting if possible.
> Tnx Glenn
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@uller.skylee.com>
> To switch to the DIGEST mode, send e-mail to
<mil-veh-digest@uller.skylee.com>
> To reach a human, contact <help@uller.skylee.com>
>

Next message: Jason E. Rose: "Re: [MV] Alternater"
Previous message: Richard Faunce: "Alternater"
Next in thread: Brandon: "Re: [MV] CARC stripper"
Maybe reply: Brandon: "Re: [MV] CARC stripper"
Maybe reply: Everett Doyle: "Re: [MV] CARC stripper"
Maybe reply: jonathon: "Re: [MV] CARC stripper"
Maybe reply: Mel Miller: "Re: [MV] CARC stripper"
Maybe reply: jonathon: "Re: [MV] CARC stripper"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b29 : Thu Jun 01 2000 - 22:37:13 PDT