Hi there:
The 8X9 plate is used with the early style "Square" Antenna tuner, if you
are using the "sugar scoop" bracket with round antenna tuner throw the plate
away.
the 30 inch angle iron is a reenforcement that goes unde the sponson and the
top row of bbolts goes thru the outer bracket, the jeep pannel and bolts
thru the angle iron. This prevents the fender from cracking behind the rear
wheel from the added stress of the ant mount. There are left and right hand
ones.
The 2 right angle brackets are reenforcements for bolting thru the fender.
Enjoy.
Hank
----- Original Message -----
From: Steven D. Cohen <sdcohen@compuserve.com>
To: Military Vehicles List <mil-veh@skylee.com>
Sent: Thursday, July 06, 2000 8:07 AM
Subject: [MV] MUTT Antenna Bracket
Installing an antenna bracket on the right rear of my MUTT and there are a
few extra parts in the kit. Would appreciate help in figuring out what
they are for.
There are two right angle brackets, an 8" x 9" plate and a 30" long braket
with a 45° bend about 3" from one end. Does anyone know what these parts
were supposed to be used for?
Thanks.
=Mil-Veh is a member-supported mailing list=
To unsubscribe, send e-mail to: <mil-veh-off@skylee.com>
To switch to the DIGEST mode, send e-mail to <mil-veh-digest@skylee.com>
To reach a human, contact <help@skylee.com>
This archive was generated by hypermail 2b29 : Mon Aug 07 2000 - 22:15:55 PDT