Daniel
I assume you are going to install a full flow system. Make sure you use at least 12mm inside diameter hoses or you may reduce your oil pressure. The PH8A filter is a bypass filter and must be hooked up in the correct direction or it will explode. I do not know if the Merkur radiator is suitable for a M151-A2. I would also recommmend using a oil tempereature thermostat. You can also run the oil too cold. Good Luck.
Dave Fillman
45 MB
---- you wrote:
> Hello List!!
>
> I wanted to adapt an oil radiator to my M151-A2. The radiator is very easy
> to install and it is only necessary to put before the original oil filter
> and them arrives upside them (no other modifications). The water hoses
> would connect them to the heating exit (in the water pump). I believe that
> to maintain or reduce the temperature of the oil it is the life of the
> motor. The oil radiator y from a FORD Merkur (or sierra) vehicle and use the
> same filter PH8.
>
> What do you think?
> -----------------------------------------------------
> Daniel A. Nadorfy P.
> dnadorfy@cantv.net
> http://www.m151a2.com
> Caracas-Venezuela
----------------------------------------------------------------
Get your free email from AltaVista at http://altavista.iname.com
This archive was generated by hypermail 2b29 : Mon Aug 07 2000 - 22:16:02 PDT