Richard Greene has a Military issue kit to tap 12v dc from a 24 volt
system. Used in the M151, but I ues one on my M35....it is very simple to
install and cheap..around $8 or 9 dollars...and its MILITARY ISSUE!
Jon
At 10:45 AM 8/14/00 -0400, you wrote:
>Hey - thanks for all your help. After being pointed in the right direction
>I found this web page. http://www.abpco.com/DC_DC_Converters_Selection.html
>which appears to have what I'm looking for. Thanks again!
>
>John
>'93 M1038
>
>-----Original Message-----
>From: Les Newman [mailto:lnewman@tridium.com]
>Sent: Monday, August 14, 2000 10:37 AM
>To: mil-veh@skylee.com
>Subject: [MV] 24v to 12v. Ooops, just noticed their address.
>
>
>Ooops. I see they may only sell to distributors. Well, still a good solution
>if it can be purchased.
>
>
>===Mil-Veh is a member-supported mailing list===
>To unsubscribe, send e-mail to: <mil-veh-off@skylee.com>
>To switch to the DIGEST mode, send e-mail to <mil-veh-digest@skylee.com>
>To reach a human, contact <help@skylee.com>
>
>===Mil-Veh is a member-supported mailing list===
>To unsubscribe, send e-mail to: <mil-veh-off@skylee.com>
>To switch to the DIGEST mode, send e-mail to <mil-veh-digest@skylee.com>
>To reach a human, contact <help@skylee.com>
>
This archive was generated by hypermail 2b29 : Sat Sep 02 2000 - 09:32:28 PDT