I would say you're going to make up some "sand channels" for your Ferret. I
seem to have seen some of those here in the Seattle area - I will see if I
can figure out where it was. I believe it was at a metal scrap yard.
Ian Wallace, Seattle
1960 Ferret Mk 2/3 (without sand channels)
> -----Original Message-----
> From: Military Vehicles List [mailto:mil-veh@skylee.com]On Behalf Of
> Robin Craig
> Sent: Monday, August 21, 2000 11:38 AM
> To: Military Vehicles List
> Subject: [MV] PSP pierced steel plating
>
>
> I am looking for some of this material, is is like a plank but in
> steel with
> three rows of round holes. These items were used as temporary runway
> material as they could be linked together by means of tangs on the sides.
> They come about 8 feet long. I need two pieces, anyone have any kicking
> around, perhaps dare I say it, In Canada?
>
> rgds
>
> Robin Craig
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@skylee.com>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@skylee.com>
> To reach a human, contact <help@skylee.com>
>
This archive was generated by hypermail 2b29 : Sat Sep 02 2000 - 09:32:32 PDT