In a message dated 10/3/00 11:46:14 AM Central Daylight Time,
CHRISM@Electroimpact.com writes:
<< TM9-8024 lists cylinder compression spec for the M135 etc. as 30-40 psi.
My cylinders read from 135-150 psi.
>>
I think you may be mis-reading the manual. TM9-8024 (October 1955) on page
188, says that the compression reading of the 6 cylinders should be within
30-40 lbs of each other. The compression ratio of the engine is 7.2 to one.
I hope this helps,
David Doyle
This archive was generated by hypermail 2b29 : Wed Nov 01 2000 - 21:37:36 PST