Any machine shop can cut off a piece of 5/16 dia. alum. and drill a couple
of holes in the ends for cotter pins. I made four for my M211 winch
Bobby Joe Pendleton II
MVPA#17657
----- Original Message -----
From: "Rikk Rogers" <rkltd@swbell.net>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Monday, 06 November, 2000 2:27 PM
Subject: Re: [MV] Winching, Wenching and drinking.........
> Aluminum! ouch!
> What else can be used?
> rikk
>
> -----Original Message-----
> From: Eugene PANTANO [mailto:snoshu@market1.com]
> Sent: Monday, November 06, 2000 12:14 PM
> To: Rikk Rogers
> Subject: Re: [MV] Winching, Wenching and drinking.........
>
>
> The aluminum pin on the front winch is supposed to have about a 11,000
> shear point....not much.... Gene
> ----- Original Message -----
> From: "Rikk Rogers" <rkltd@swbell.net>
> To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
> Sent: Monday, November 06, 2000 12:02 PM
> Subject: [MV] Winching, Wenching and drinking.........
>
>
> > Ok,
> > I heard this discussed on the list, but please and again for those of us
> who
> > are a bit slow....
> > What are the specs on the shear pit in the front winch on a M35A2?
> >
> > Later I'll type up the reasons why I'm asking.....
> >
> > It IS easier to stick em, that to un-stick em!!
> >
> > Rikk Rogers - RK Lion LTD.
> > 416 S 4th St
> > Ponca City OK. 74601-5335
> > (580)762-3157 rkltd@swbell.net
> > http://home.swbell.net/rkltd/
> > -M35A2- MVPA -22345-
> >
> >
> >
> > ===Mil-Veh is a member-supported mailing list===
> > To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> > To switch to the DIGEST mode, send e-mail to
<mil-veh-digest@mil-veh.org>
> > To reach a human, contact <ack@mil-veh.org>
> >
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
This archive was generated by hypermail 2b29 : Sun Dec 03 2000 - 20:29:47 PST