More correctly, I took wire off resister and ran to 12v block for 12 v feed.
Right?
Stuart J. Ellis
East Coast Sales Manager
Intraco USA
Web Site: www.intraco.com.sg
Phone: 603-437-1392 Fax: 603-437-6046
Notice :- This message (including all attachments) contain privileged &
confidential information and is subject to the disclaimer notice as set out
at http://www.intraco.com.sg/disclaim_official.htm
----- Original Message -----
From: "Julian Burke" <julianb@esper.com>
To: "Stuart Ellis" <stuellis@mediaone.net>
Sent: Tuesday, November 21, 2000 9:33 PM
Subject: Re: [MV] Hard starting Blazer Update
> You don"t "bypass" the glowplug resistor. See my previous postings on
this
> very subject.
>
> > Hi all!
> > So far shop has found that NEW GM fuel lift pump was BAD. had blockage.
> > That why I could not get system primed. Also looks like resister was
bad
> > and may have burnt out some of the new glow plugs. I bypassed resisters
> > before truck was towed to shop. Glad I didn't fill cab with gas and
toss
> > match.
> > Stuart J. Ellis
> > East Coast Sales Manager
> > Intraco USA
> > Web Site: www.intraco.com.sg
> > Phone: 603-437-1392 Fax: 603-437-6046
> >
> > Notice :- This message (including all attachments) contain privileged &
> > confidential information and is subject to the disclaimer notice as set
> out
> > at http://www.intraco.com.sg/disclaim_official.htm
> >
> >
> >
> > ===Mil-Veh is a member-supported mailing list===
> > To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> > To switch to the DIGEST mode, send e-mail to
<mil-veh-digest@mil-veh.org>
> > To reach a human, contact <ack@mil-veh.org>
>
This archive was generated by hypermail 2b29 : Sun Dec 03 2000 - 20:29:56 PST