----- Original Message -----
From: "Ken Boge" <ken@clovermachine.com>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Friday, November 24, 2000 9:33 PM
Subject: Re: [MV] RE Body thickness
> If anyone needs a sheet metal thickness chart, there's a nice one at
>
> http://www.eagle.ca/~ucs/2carb.html
>
Perhaps even better is http://www.screentg.com/gaugewire.htm
This gives all the gauge number standards and their nominal inch thickness.
Richard
Southampton - England
This archive was generated by hypermail 2b29 : Sun Dec 03 2000 - 20:29:58 PST