Sounds like the teeth are gone from the flexplate..they are cheap...about
$35..
DO NOT REMOVE TRANSMISSION TO REPLACE....!!! Just remove all the bolts from
the bellhousing and transmission/transfer case mounts...unbolt the
transmission filler tube at the top...have 2 6 or 8 inch long bolts to
install in place of two bellhousing retaining bolts....(I leave the starter
in place)..oh...unhook batteries before doing anything !!) Depends on the
rear drive shaft whether or not you have to unbolt it from the
differential...same with the front...some vehicles are forgiving -- some are
not --play it by ear....if the trans will slide back without unbolting the
drive shafts..go for it !
Now after removing flywheel inspection cover..unbolt the 6 bolts from the
torque converter-----slide the whole transmission/transfer back far enough
to get a 6" piece of 2X4 in the opening with the 4" width...now you can
unbolt the flexplate and install a new one..! Should take less than an hour.
If it is not the flex plate....low batteries will cause the starter to make
horrific noises...and still start the vehicle...sometimes ! Good luck, Gene
----- Original Message -----
From: "Stuart Ellis" <stuellis@mediaone.net>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Saturday, December 02, 2000 12:48 PM
Subject: [MV] New Blazer problem
> Hi all!
> Replaced bendix around a month ago because of loud sound starter would
make
> while trying to start that I was told was bad Bendix. Problem went away
> after, and truck, other than cold starting, would start ok without
multiple
> tries to get away from worn spots.
> Today, it took 3 tries while starter made same sounds like it used to,
> before finally getting it to crank normally and start. Drove it home and
> tried starting in the driveway and it took twice, making the same sound
the
> first time and started the second time after normal cranking sound.
> Any ideas what could be wrong now?
>
> Stuart J. Ellis
> East Coast Sales Manager
> Intraco USA
> Web Site: www.intraco.com.sg
> Phone: 603-437-1392 Fax: 603-437-6046
>
> Notice :- This message (including all attachments) contain privileged &
> confidential information and is subject to the disclaimer notice as set
out
> at http://www.intraco.com.sg/disclaim_official.htm
>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
>
This archive was generated by hypermail 2b29 : Tue Jan 02 2001 - 23:13:20 PST