If I remember right, the bolts for the pump gear are behind a grommet, no
need to change that unless it is cracked, etc.
----- Original Message -----
From: Stuart Ellis <stuellis@mediaone.net>
To: Military Vehicles Mailing List <mil-veh@mil-veh.org>
Sent: Wednesday, December 06, 2000 11:04 AM
Subject: [MV] Timing Cover Gasket for 1009
> Hi all!
> Manual calls for a new timing cover gasket when changing the injection
pump.
> GM says there is no such thing. Who's right??
>
>
> Stuart J. Ellis
> East Coast Sales Manager
> Intraco USA
> Web Site: www.intraco.com.sg
> Phone: 603-437-1392 Fax: 603-437-6046
>
> Notice :- This message (including all attachments) contain privileged &
> confidential information and is subject to the disclaimer notice as set
out
> at http://www.intraco.com.sg/disclaim_official.htm
>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
This archive was generated by hypermail 2b29 : Tue Jan 02 2001 - 23:13:20 PST