I could not remember what the Manual said on the Heater, I was just sure
that I was not running it right.
So, I went and looked it up in those fine manuals on CD from Military Media.
TM 9-2320-209-10-1
Figure 4-42
Page 96 of 594 (no page # on page)
CAUTION
Do not operate manifold heater unless engine is idling
or being cranked. Engine can be damaged.
1. While engine is being cranked, turn MANIFOLD HEATER SWITCH (1) to ON.
The engine should start and run within 30 seconds
.
2. If engine does not start in 30 seconds, turn MANIFOLD HEATER SWITCH (1)
to OFF and stop cranking engine.
3. Wait two minutes and do steps 1 and 2 again above.
NOTE
If engine misses or does not run smoothly after starting,
turn MANIFOLD HEATER SWITCH (1) ON for 30 seconds,
then OFF. Wait a few seconds and do it again until engine
runs smoothly.
Rikk Rogers - RK Lion LTD.
416 S 4th St
Ponca City OK. 74601-5335
(580)762-3157 rkltd@swbell.net
http://home.swbell.net/rkltd/
-M35A2- MVPA -22345-
This archive was generated by hypermail 2b29 : Tue Jan 02 2001 - 23:13:23 PST