Is there not a ground in the wire bundle connected in the screw-on
connection?
rikk
-----Original Message-----
From: Military Vehicles Mailing List [mailto:mil-veh@mil-veh.org]On
Behalf Of TacticalTruck@aol.com
Sent: Thursday, December 14, 2000 10:40 PM
To: Military Vehicles Mailing List
Subject: Re: [MV] M35 turn signals
Chuck
I'm not sure about the problems being related but intermittent turn signal
problems can be caused by a weak ground between the turn signal lever and
the
steering column. Loosen the hose clamp holding it on and scrape some of the
paint off the column under the spot where the lever mounts. There are four
sharp feet the lever sits on. Make sure there's a good connection there.
Jeff
TacticalTruck.com
===Mil-Veh is a member-supported mailing list===
To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2b29 : Tue Jan 02 2001 - 23:13:23 PST