Lock out hubs for the rear axles would be an AWESOME idea, but I can't think
of a way to make (invent) them. This conversation got me thinking about
such a thing.
Joe Garrett
cell 206-228-6846
-----Original Message-----
From: Military Vehicles Mailing List [mailto:mil-veh@mil-veh.org]On
Behalf Of mblair1@home.net
Sent: Sunday, January 21, 2001 9:03 AM
To: Military Vehicles Mailing List
Subject: Re: [MV] Deuce Hubs
KAYE-RIVERCITY@webtv.net (Geof Kaye) wrote:
> Don't count on improving your fuel mileage with the hubs.
I'm brashly assuming that these are hubs for the front wheels (please
correct me if I'm wrong).
Does anybody make good-quality lockable/unlockable hub/axle
combinations for the middle/rear axles? An article in MV Mag a while
back stated that disconnecting one set of wheels made the truck drive
a lot better on pavement, by eliminating drivetrain wind-up. On the
other hand, I think some folks have said that doing that can make the
truck get stuck a lot easier, due to the reduced traction. It seems to
me that having switchable hubs on one of the rear axles might offer
the best of both worlds.
An air-switchable clutch between the middle/rear axles might be even
nicer, but I figure that would be much more difficult and expensive to
make.
I balanced out the tire circumferences on each dual (within 1/4") and
the average circumference between the two rear axles (within 1/2") as
well as I could, but my truck still makes visible tire tracks on
concrete. That suggests to me that the tires are scrubbing, and I have
a hunch that disconnecting one of the axles might greatly reduce that,
but I don't want to give up the ability to have all wheels driving
under less-than-ideal conditions.
Opinions?
-- Mark J. Blair, KE6MYK <mblair1@home.net> PGP 2.6.2 public key available from http://www.keyserver.net/ Web page: http://www.qsl.net/ke6myk/ DO NOT SEND ANY UNSOLICITED COMMERCIAL EMAIL TO THIS SITE PLEASE SEND PLAIN ASCII TEXT ONLY -- NO HTML OR QUOTED-PRINTABLE===Mil-Veh is a member-supported mailing list=== To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2b29 : Mon Feb 05 2001 - 07:13:50 PST