I believe the axle nut for the split CCKW is a standard that you can buy at
a truck brake place.
The guy from Canada (not Brian Asbury) has/will have the data plates. I
talked to him in Ft Lee
Steve AKA Dr Deuce
----- Original Message -----
From: "Drew Ballard" <aballard@toolcity.net>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Monday, August 13, 2001 5:59 PM
Subject: [MV] CCKW plates and Tool
> Can any of you guys tell me where I might find repro data plates and the
> smaller wheel bearing nut wrench (split axle) for a CCKW?
>
> Plates-I had Marty Fravel of Division Ordnance in VA recommended but I've
> been emailing him since May and only gotten 1 reply "did I ever get back
to
> you on this?" Has anyone else ever had these plates made?
>
> Wrench-I need the smaller of the 2 bearing nut wrenches for a split axle.
> It would be hex shaped, not round with protruding fingers (banjo axle). I
> tried Vermont Commercial salvage, he said they were for split axle, when I
> got one it was for the banjo axle. Is there anyone else? I've struck out
> with any parts guys so far, and I haven't been able to make the last
couple
> MV rallies to hunt for one.
>
> Thank you very much for any assistance.
> Drew
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2b29 : Sun Sep 02 2001 - 11:15:38 PDT