You go to a hardware store on Edgeware Road and buy a selection there.
John
Richard Notton wrote:
> ----- Original Message -----
> From: "J. Forster" <jfor@onemain.com>
> To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
> Sent: Wednesday, September 05, 2001 12:28 AM
> Subject: Re: [MV] CUCV jerry can bracket holes?
>
> > Go to your local hardware store and buy one of each size and thread bolt
> between
> > 1/4" and 1/2" , english and metric if requires, and write the size on
> each.
> > Presto, instant thread guage for about $2.
> >
> Ah, but how do you tell if the "English" is BSF, Whitworth, BA or BSA cycle
> thread ?
>
> Richard
> Southampton - England
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2b29 : Mon Oct 08 2001 - 10:58:56 PDT