You don't need the pump in the tank. Run a line in and install a lift pump
in the frame channel. Commercially available pumps are no where near as
expensive as the unit that goes in the tank.
Best of luck,
-=-
----- Original Message -----
From: "D Russo" <drusso@together.net>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Sunday, September 09, 2001 9:11 AM
Subject: [MV] M35 in tank pumps
> Has anyone figured out a way to rebuild the motors on the deuce in-tank
fuel pumps?
> Are the motors silver soldered into their case?
>
> Maybe I will contact Tolkheim and see if one of their dealers would touch
it (doubtful)
>
> Thanks for any ideas
> Dave Russo
>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2b29 : Mon Oct 08 2001 - 10:58:57 PDT