If you don't want to fill it with water and weld on a new bottom you can use
JB Weld, the slow dry kind. Sand blast it clean and trowel on the JB Weld
and let it dry, I have done it on two vehicles and it works.
Ed Morgan
-----Original Message-----
From: don burris <dburrissprint@earthlink.net>
To: Military Vehicles Mailing List <mil-veh@mil-veh.org>
Date: Thursday, September 20, 2001 9:44 PM
Subject: [MV] M211 fuel tank
>The fuel tank on one of my M211's went from being a receptacle to being a
>rain bird sprinkler. After steam clean and clean up I found a bunch of pin
>holes in the bottom. Any repair suggestions or should I turn it into a
>planter and put it in the front yard?
>
>
>===Mil-Veh is a member-supported mailing list===
>To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
>To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
>To reach a human, contact <ack@mil-veh.org>
>
This archive was generated by hypermail 2b29 : Mon Oct 08 2001 - 10:59:00 PDT