I did mine the same way Joe says, just pull the pin and you will have enough
Jon
> >>removing either the radiator or air compressor.
> Don't go there! I think we undid the clamp that holds the radiator brace to
> the top
> of the engine. Just took the bolt out of the clevis and I think we could then
> move
> the radiator about a 1/4" or so forward to give us the clearance.
> Joe Young.
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
This archive was generated by hypermail 2b29 : Fri Dec 07 2001 - 00:36:59 PST