My post on the PM brake switch MWO article is in the archives here:
http://www.mil-veh.org/archives/01-01/0243.html
The issue of PM Mag it came from is not online. I will see if I can find the
issue and scan the article and let the list know if I do find it.
BTW...
Does anyone on the list have the switch upgrade kit NSN 2530-01-105-5025?
Ron
----- Original Message -----
From: "uniquemachine" <uniquemachine@air1.net>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Saturday, December 08, 2001 11:39 AM
Subject: [MV] M35A2 brake switch
> I am in the process of changing out the front wiring harnass
> on my M35A2 and have come across a situation taht I would
> like some input from. The new wiring harnass that I got has
> a large plug for the brake light switch(same as the one for
> the in tank fuel pump) but the old wiring harnass uses two
> small(packard type) connectors. Then, while under the
> truck, I saw that the brake master cylinder has a brake
> switch connector on the end of it that is for the large
> single plug(not used) but there was also another switch that
> was tee'd into the brake line that used the two small
> plugs(this one was being used). I remember reading a
> discussion about brake switches on the list a while back,
> but I don't remember the specifics. Any help?
>
> Jon
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2b29 : Sun Jan 06 2002 - 22:26:51 PST