But you still need to add the 4bt Cummins installion stuff.
Rick
---------- Original Message ----------------------------------
From: cgarbee@ipass.net
Date: Thu, 24 Jan 2002 09:35:26 -0500 (EST)
>I have the dimensions on my webpage at:
>www.garbee.net/~cabell/bedwood.htm
>
>The dimensions are the ones that I used for the
>fabrication of the wood on my '53M37 and were sent to me
>by participants of the bigelectric.com M37 forum.
>
>I also have some pictures of the truck on the site, but
>I haven't put up any of the truck with the bows
>installed or the canvas on the bed yet...
>
>C. Garbee
>'53M37 3/4 ton cargo truck
>'66M101 3/4 ton trailer
>
>Quoting "Doyle, John D" <JDoyle@framatech.com>:
>
>>
>> Some time back I asked for information on dimensions
>of
>> a set of cargo bows for an M37. I got a few answer,
>all of
>> which were slightly different.
>>
>> I'm not so much worried about the length of the bows-
>I'll measure
>> the garage to determine that. But I'm curious if
>anybody has
>> a set on their truck and can give me the width and
>depth numbers?
>>
>> Thanks,
>> John
>>
>> ===Mil-Veh is a member-supported mailing list===
>> To unsubscribe, send e-mail to:
><mil-veh-off@mil-veh.org>
>> To switch to the DIGEST mode, send e-mail to
><mil-veh-digest@mil-veh.org>
>> To reach a human, contact <ack@mil-veh.org>
>>
>
>
>===Mil-Veh is a member-supported mailing list===
>To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
>To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
>To reach a human, contact <ack@mil-veh.org>
>
This archive was generated by hypermail 2b29 : Wed Feb 06 2002 - 11:49:33 PST