From: Buzz Szarek (buzz@toast.net)
Date: Tue Feb 26 2002 - 05:02:25 PST
The home made one is likely better than the mil version. The mil 'wrench'
is made out of cast metal. It's soft as heck and will round out if the
pulley is stuck.
-=-
----- Original Message -----
From: "uniquemachine" <uniquemachine@air1.net>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Tuesday, February 26, 2002 1:03 AM
Subject: Re: [MV] M-35A2 air compressor pulley tool needed.
> I made one at my shop out of a 1/8" thick steel plate.
>
> Jon
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Mon Apr 08 2002 - 00:24:48 PDT