How to use Lug Wrench for M35

From: Mark Ehle (markehle@hotmail.com)
Date: Fri Mar 01 2002 - 10:24:10 PST

• Next message: Henry Fackovec: "Re: [MV] How to use Lug Wrench for M35"
• Previous message: Darrell Shake: "Distributor, GMC , 6 cylinder FS"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hello, Folks -

I have to remove one of the rear wheels on my M35. It is on the driver's
side, so I finally figured out that the threads are left-handed. However, I
am not able to loosen any nuts with my 2-piece wrench.

I have been supporting the outboard end of the wrench on a jack stand, and
jumping on the end of the handle. The only thing my 275+ pounds has succeded
in doing is to bend the handle a little.

Am I doing something wrong, or are they just too tight? Also, Is a 3/4"
impact sufficient for these nuts, or would a 1" be a wiser choice?

Thanks,

Mark Ehle

Dowling, MI

_________________________________________________________________
MSN Photos is the easiest way to share and print your photos:
http://photos.msn.com/support/worldwide.aspx

• Next message: Henry Fackovec: "Re: [MV] How to use Lug Wrench for M35"
• Previous message: Darrell Shake: "Distributor, GMC , 6 cylinder FS"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Mon Apr 08 2002 - 00:26:47 PDT