From: Rikk Rogers (rkltd@swbell.net)
Date: Fri Mar 01 2002 - 12:15:42 PST
I'm thinking Battle Bots are MV R&D.
Isn't the US Military testing a radio controlled system with a 20mm gating
gun on it?
just a thought....
-----Original Message-----
From: Military Vehicles Mailing List [mailto:mil-veh@mil-veh.org]On
Behalf Of Jim Newton
Sent: Friday, March 01, 2002 1:23 PM
To: Military Vehicles Mailing List
Subject: [MV] Looking for Tapered Wheel Bearings with 1.25" ID Bore...
Hi List...
Does anyone know of any tapered wheel bearings and races from an MV or
civy vehicle that has an inside bore of 1.25" to go on a 1.25" axle?
All the application charts I've found list only the vehicle for which
the bearing is for, not the inside diameter.
I'm looking for these for my BattleBot. OK, it isn't exactly
MV-related, but my BattleBot does have tracks, and our BattleBots team
uses my deuce to attend the events. Is that MV-related enough?
Thank you!
--Jim "Ike" Newton
o 1984 M1007 CUCV Military Suburban 6.2 Liter Turbo-Diesel Engine 5/4 Ton Cargo Capacity, 4WD
o 1971 M35A2 Military Troop/Cargo Truck "Deuce and a Half" 478 Cubic Inch Turbo-Diesel Multi-Fuel Engine Air Shift Front Axle 2 1/2 Ton Cargo Capacity, 6WD
See them at: http://www.CUCV.net
=Mil-Veh is a member-supported mailing list= To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Mon Apr 08 2002 - 00:26:47 PDT