From: Glen Bedel (GBedel@designforum.com)
Date: Thu Mar 28 2002 - 08:00:01 PST
"Just a suggestion".............."Rhino Lining"
-----Original Message-----
From: RKubu@aol.com [mailto:RKubu@aol.com]
Sent: Thursday, March 28, 2002 10:55 AM
To: mil-veh@mil-veh.org
Subject: Re: [MV] [MVlist] CUCV Blazer Rubber Floor matting and
Insulation
List,
I have a strong recommendation against re-installing the rubber floor mat in
your M1009s. I say "re-install"
because the truck most likely had one when it was new. These mats are
commonly removed...and for good reason. They retain water in the cab which
causes the floor to rust through. Unless your truck is not going to get
wet...ever...and most CUCVs leak a bit...I would recommend that you avoid
installing the rubber floor mat. I had an M1009 with a rubber floor mat in
it when I purchased it. When I removed it, I found four holes in the cab
floor, the largest of which you could drop a tennis ball through.
Bruce
1957 M125 w/w
1966 M172A1
1971 M35A1
1971 M35A2
1972 M35A2
1972 M35A2C w/w
1982 M548A1 w/w
1984 M929
1984 M932 w/w
===Mil-Veh is a member-supported mailing list===
To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Mon Apr 08 2002 - 00:28:31 PDT