Need Help

From: Dan & Pam (pamelakg@intergate.ca)
Date: Sun May 05 2002 - 18:07:10 PDT

• Next message: Cav43rdBn@aol.com: "Re: [MV] Painting the white lettering on Commo gear"
• Previous message: Michael Sloan: "Re: [MV] Polishing Gauge lenses"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hello List!

I'm looking for suggestions on an easy way to take the adhesive back foam
padding off the R.O.P.S. roll over cage on a M151A2. I've been using heat
and cutting with a knife - it's a very messy and time consuming method. I
was hoping someone else had been through this and may have suggestions on an
easier way to remove the padding. I've completed 1/3rd of this job and
there is no turning back.

Any suggestions would be greatly appreciated.

Thanks!
Pam & Dan

• Next message: Cav43rdBn@aol.com: "Re: [MV] Painting the white lettering on Commo gear"
• Previous message: Michael Sloan: "Re: [MV] Polishing Gauge lenses"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Fri Aug 16 2002 - 11:20:41 PDT