From: Dave Cole (DavidCole@tk7.net)
Date: Wed Jun 05 2002 - 08:44:04 PDT
Has anyone ever tried using one of the new inertia electronic braking units and dropping the voltage and current to the braking unit with resistors?
I'm not big into cutting into hydraulic brake lines, especially when they are below the floor!
Dave
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>.
6/4/2002 8:40:00 PM, jonathon <jemery@execpc.com> wrote:
>
>>3. I plan to pull a trailer with electric brakes. I have several "plans" on
>>how I'm going to do this, but none of them are easy. Has anybody figured
>>out an easy way to do this? Anybody run across a company that sells parts
>>designed for a 24 volt truck?
>
>Use a normal Kelsey-Hayes hydraulicaly actuated brake controller. Get at
>least two of the K-H adjustable load resistors and use them ( 2 or 3) in
>series connected to the normal 24V supply to adjust max current to brakes.
>
>later,
>
>je
>
>
>===Mil-Veh is a member-supported mailing list===
>To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
>To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
>To reach a human, contact <ack@mil-veh.org>
>
This archive was generated by hypermail 2.1.4 : Fri Aug 16 2002 - 11:22:40 PDT