From: Robert Barber (rbarber41@hotmail.com)
Date: Sat Jun 08 2002 - 19:24:03 PDT
I used to use Cleveite "77" bearings in both small and big
block Chevy race engines spinning up to 8000 plus each.
I never had "softness" problems, so unless their quality
has gone bad in the last number of years I'de say they
should be fine to use ..
Bob B
>From: "Piotr Domownik" <domator@file.com.pl>
>To: <mil-veh@mil-veh.org> (Military Vehicles Mailing List)
>Subject: [MV] CUCV 6.2 diesel parts - where to find it ?
>Date: Sat, 8 Jun 2002 13:53:01 +0200
>
>Hi,
>
>Does anyone have any idea what store [eStore, preferaby:)] I can buy rod
>and
>main bearings for '86 Chevy 6.2 diesel. They have some at SummitRacing, but
>these are made by Clevite. I heard their bearings aren't of the best [too
>soft]. What's your opinion on that? I'm also looking - also to no avail -
>for a high volume oil pump for the same engine. I've seen enforced bearings
>and racing pumps for gasoline engines advertised in many places. Is it so
>different with diesels?
>
>
>Piotr
>
>
>
>
>
>===Mil-Veh is a member-supported mailing list===
>To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
>To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
>To reach a human, contact <ack@mil-veh.org>
_________________________________________________________________
MSN Photos is the easiest way to share and print your photos:
http://photos.msn.com/support/worldwide.aspx
This archive was generated by hypermail 2.1.4 : Fri Aug 16 2002 - 11:22:48 PDT