From: Charlie (seacoastsurplus@worldnet.att.net)
Date: Thu Aug 16 2001 - 23:06:54 PDT
Anyone need WWII 57mm Bore Brushes??/
I have those (just a couple)
At 07:39 PM 6/14/02, you wrote:
>Thise brushes were made by the Fuller Brush company.......extremely hard to
>find......buy them all...as have been looking for 3 years.....
>
>Jon
>----- Original Message -----
>From: <Renactr2@aol.com>
>To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
>Sent: Friday, June 14, 2002 1:28 PM
>Subject: [MV] Do you have these for sale???
>
>
> > Hi List,
> > For a 1942 Humber Armoured Car. But also used on American armour.
> >
> > US 37mm Bore Brush and rammer. The bore brush is made of fiber bristles.
>the
> > lower end of the brush is provided with an external threaded stud which
>can
> > be screwed into the thread end of the forward section of the rammer.
> > The rammer consists of two sections. The forward section is threaded at
>both
> > ends. One end is threaded to receive the cleaning brush and the other end
>the
> > rear section of the rammer.
> >
> > Also 37 MM Protective muzzle cover. It is made of heavy leather
> >
> > Tool Roll, M6 Made of canvas.
> >
> > Replies off list to:
> > Jim Burrill
> > Renactr2@aol.com
> > or call
> > 215-529-7035
> >
> > TIA
> > Jim
> >
> > ===Mil-Veh is a member-supported mailing list===
> > To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> > To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> > To reach a human, contact <ack@mil-veh.org>
> >
>
>
>===Mil-Veh is a member-supported mailing list===
>To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
>To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
>To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Fri Aug 16 2002 - 11:23:05 PDT