RE: [MV] How do you separate.... Thanks

From: Mugno, Anthony (AMugno@SITAAPS.org)
Date: Thu Jul 11 2002 - 07:20:03 PDT

• Next message: SPNOTHER@aol.com: "Re: [MV] Brake Line replacements"
• Previous message: Glen Bedel: "RE: [MV] Paint & Rust Removal"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Well tell us how you did it!!!! then one of us can gloat!!!

Tony Mugno
Senior Systems Integration Engineer
S.I.T.A. Systems Integration Group
55 Orville Drive
Bohemia, New York 11716
v. 631 218 4593
fax 631 563 3918
amugno@sitaaps.org
STX NYCHJXS

-----Original Message-----
From: J. Forster [mailto:jfor@quik.com]
Sent: Wednesday, July 10, 2002 11:21 PM
To: mil-veh@mil-veh.org
Subject: [MV] How do you separate.... Thanks

Thanks for all the replies. They were very helpfull. I got the thing appart
without damage to anything. Now all I need is an expert welder to fill in
the
missing cast iron areas.

Thanks again,
John

===Mil-Veh is a member-supported mailing list===
To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
To reach a human, contact <ack@mil-veh.org>

• Next message: SPNOTHER@aol.com: "Re: [MV] Brake Line replacements"
• Previous message: Glen Bedel: "RE: [MV] Paint & Rust Removal"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Fri Aug 16 2002 - 11:24:22 PDT