From: Michael J. Hill (wild800@pacbell.net)
Date: Mon Jul 22 2002 - 19:11:19 PDT
Hi Craig,
Try checking the fusible link. You might be able to see it visibly,
sometimes one can feel the break (it will feel wiggly at the break<--
high tech terminalogy LOL) in the link. Or one can use a meter to
measure the continuity. Also you should see a difference in your amp
gauge it will be below the little bump marking in the green zone. Hope
this helps.
Mike Hill EMT-1
Kilo Golf Six Foxtrot Juliet India
1986 M1009
M105A2
ccclifton@telis.org wrote:
>
> The #2 light use to come on when starting, now it doesn't. Once started
> the light glows but only very dim, in fact you really have to look at it
> to notice it is on. Never did this before. Would come on as #1 did
> and once started go out.....
>
> Acts like the diode is going out.
>
> Any suggestions or ideas on this problem.
>
> Thanks,
>
> Craig Clifton
> ccclifton@telis.org
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Fri Aug 16 2002 - 11:24:51 PDT