From: Steve & Jeanne Keith (cckw@attbi.com)
Date: Thu Aug 15 2002 - 14:10:32 PDT
The output is 110 I believe. It is only 3 phase which is unusual for an
output that low unless maybe it was only to run a motor.
It weighs 308 pounds and is skid mounted. This one is in nice condition
Steve
----- Original Message -----
From: "kuhrick" <kuhrick@comcast.net>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Thursday, August 15, 2002 5:04 PM
Subject: Re: [MV] 3 kw ww2 genset
> there was made a 3 kw 3 phaze gen set that usewd allmost a jeep sized
water
> cooled motor
> it had 3 110 volt outputs to grond and 220 if wared phaze to phaze
> and all 3 legs made 220 3 phaze
> i seen one runing 3 weeks a go it runs as good as new
> big and havey but will out live you if cared for
> low speed too
>
>
> ----- Original Message -----
> From: "Steve & Jeanne Keith" <cckw@attbi.com>
> To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
> Sent: Thursday, August 15, 2002 2:47 PM
> Subject: [MV] 3 kw ww2 genset
>
>
> > I am picking up a 3 kw genset from ww2. It is 3 phase shich is unusual
for
> > that low current. It also turns at 1200 rpms to make 60 hz which for a
> > genset,
> > modern or old is unusual.
> >
> > The only thing I can think of that this would be used on was the ww2
cckw
> > machine shop van to run the motors of the lathe etc
> >
> > Ideas?
> >
> > Thanks
> > Steve AKA Dr Deuce
> >
> >
> >
> > ===Mil-Veh is a member-supported mailing list===
> > To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> > To switch to the DIGEST mode, send e-mail to
<mil-veh-digest@mil-veh.org>
> > To reach a human, contact <ack@mil-veh.org>
>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
This archive was generated by hypermail 2.1.4 : Fri Aug 16 2002 - 11:39:08 PDT