From: ddoyle9570@aol.com
Date: Fri Nov 01 2002 - 20:15:16 PST
Any of you folks have any first hand experience removing the bed, earth auger and rear winch from a M764 deuce pole setter.
The TM for the earlier (but very similar) V18A/MTQ deuce pole setter says to remove the winch, the auger, then the bed.
I have been unable to locate a manual that covers this process for the M764.
HOWEVER, on Mark Blair's website, there is shown one of these beds, which was evidently removed intact. See:
http://www.qsl.net/ke6myk/greentruck/m44pics/p05.jpg
Anyone know for sure how this was done?
Still looking for the door mounted data plates for one of these vehicles too.....
Thanks,
David Doyle
This archive was generated by hypermail 2.1.4 : Wed Apr 23 2003 - 13:37:49 PDT
