From: Buzz (buzz@softcom.net)
Date: Mon Dec 02 2002 - 09:59:47 PST
Jeff,
Since I am building a M151, MRC-108 FAC jeep, I found at least one use for the "AC" wire. It is
used along with a small circuit box to convert AC to DC to drive a special volt meter to indicate
RPM. I'd be interested to learn of other uses.
Buzz
btw, did you get your manuals??
On Mon, 2 Dec 2002 06:47:55 -0800 (PST), you wrote:
>QUESTION??????
>
>
>I am using a M151A2 60 amp altenator to replace the
>one off a HUMV.
>
>I hooked it up fine and is charging well.(except for
>the #2A Wire)
>
>on the HUMV alt. there is a threaded stud to hook up
>#2A but on the M151A2 Alt there is just a solder point
>where the threaded stud #2A should be. is this the
>same as the HUMV alt threaded stud but just a solder
>point?? (I have #2A Wire disconnected)
>
>I looked at the HUMV schematic and it says #2A is AC
>Tap??
>
>any help??/
>
>Jeff Smith MVP
>850-475-5030
>Pensacola, FL
This archive was generated by hypermail 2.1.4 : Wed Apr 23 2003 - 13:24:40 PDT