From: Amnon (amnon@deltaforce.net)
Date: Tue Dec 17 2002 - 05:54:17 PST
In the past I found out that pouring a little brake fluid into the "jar", just
enough for the tip of the tube to be covered, helps avoid sucking air back into
the system.
> You install a piece of clear plastic tubing on the end of the bleeder and
> run the other end into a pan or small jar. Pump the brakes a couple of times
> and then look at the plastic tubing. There will be air bubbles in the
> tubing. Pump the brakes some more and so on until there are no air bubbles
> in the tubing. Tighten the bleeder and remove the tubing. Don't forget to
> top off the reservoir when your done.
Shalom Ya'll
Amnon Nissan
Deltaforce
919-852-2121
http://www.deltaforce.net
Host, Computers 2K2
on 850 The Buzz (AM 850) in Raleigh NC
Sundays 8-10am
http://www.850thebuzz.com/compute.html
MV stuff are at:
http://www.deltaforce.net/deuce/
http://www.deltaforce.net/cucv/
http://www.ncmvpa.com
This archive was generated by hypermail 2.1.4 : Wed Apr 23 2003 - 13:24:42 PDT