From: Eugene Pantano (truks@cs.quik.com)
Date: Thu Jan 16 2003 - 09:34:03 PST
Kinda -- sorta.. You need the resistors and the 2 switches to allow you to
have the speed control on the blower.. Just the 1 wire will only allow
"full" voltage for full speed on the blower..! Gene
> Good afternoon all. I am putting a heater in my deuce that is a NOS M151
> heater. It has one wire. I am assuming that wire is provided with 24
volts
> and the motor grounds to the frame. Is this correct? I would hate to
burn
> it up. I just plan to have a toggle switch to cut it ON or OFF. Don't
care
> about speed. It is going to be 18 degrees here Saturday morning and I
have
> to leave home at 05:00 hours. Gotta have something to warm the wind
tunnel
> a little. My propane heater makes me nervous.
This archive was generated by hypermail 2.1.4 : Wed Apr 23 2003 - 13:24:59 PDT