Re: [MV] hard start CUCV

From: Michael J. Hill (wild800@pacbell.net)
Date: Sat Jan 25 2003 - 11:40:14 PST

• Next message: Ed Kirkley: "Fuel Filter Heater Needed"
• Previous message: JJ&A: "Re: [MV] 24V Jumper Cables solution: adapter"
• Maybe in reply to: Stu Ellis: "Re: [MV] hard start CUCV"
• Next in thread: Nelson Fortson: "Re: [MV] hard start CUCV"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Dave Jenkins wrote:
Dave and list,

Here is from manual:TM 9-2320-289-20
Disconnect each glow plug lead and check for resistance between glow
plug terminal and ground. Resistance should be 1-3 ohms. Check glow
plugs for looseness or damage.

I can't remember if this is for the Wellman or the delco though.

Mike Hill
> Derek,
> What should the resistance be for a good glow plug?
> Dj
>

• Next message: Ed Kirkley: "Fuel Filter Heater Needed"
• Previous message: JJ&A: "Re: [MV] 24V Jumper Cables solution: adapter"
• Maybe in reply to: Stu Ellis: "Re: [MV] hard start CUCV"
• Next in thread: Nelson Fortson: "Re: [MV] hard start CUCV"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Wed Apr 23 2003 - 13:25:03 PDT