From: Glenn Shaw (wolf.star@verizon.net)
Date: Sun Jan 26 2003 - 09:18:40 PST
Hi
The preferred way is not to have any adapters at all and use either the old
or new style slave cable as needed. You can find as has been said the
adapters easily to convert the new cables to the old 2 pin receptacle. The
other adapter you mention to convert old 2 pin cables to new NATO style
receptacles are rare if even able to be found. IMO if you are always going
to be using only the old 2 pin style vehicle recepacles buy a old style 2
pin cable set. But if you want to be able to use the cables on all the gear
out there, get a new NATO style slave cable and a pair of adapters to go to
the old style 2 pin plugs. Then you will have the better made heavier duty
NATO cables and using your 2pin adapters you can hook up to any military
equipment.
Glenn
MVPA
MTA NJ
----- Original Message -----
From: "Amnon" <amnon@deltaforce.net>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Sunday, January 26, 2003 12:08 PM
Subject: Re: [MV] 24V Jumper Cables
>
> So what's the preffered way:
>
> 1. Cables with two pins connectors on both ends utilizing an adapter to
convert
> one end to NATO one pin.
>
> 2. Cables with NATO one pin connectors on both ends utilizing an adapter
to
> convert one end to two pins (for the Deuce)
>
>
> Shalom Ya'll
> Amnon Nissan
>
> Deltaforce
> 919-852-2121
> http://www.deltaforce.net
>
> Host, Computers 2K3
> on 850 The Buzz (AM 850) in Raleigh NC
> Sundays 8-10am
> http://www.850thebuzz.com/compute.html
>
> MV stuff are at:
> http://www.deltaforce.net/deuce/
> http://www.deltaforce.net/cucv/
> http://www.ncmvpa.com
>
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Wed Apr 23 2003 - 13:25:04 PDT