Re: [MV] M151a2-Proper way to seal exhaust manifold

From: MVTrucker@aol.com
Date: Thu Feb 27 2003 - 22:00:36 PST

• Next message: tom-nooneofconsequence: "(no subject)"
• Previous message: tom-nooneofconsequence: "(no subject)"
• Maybe in reply to: Steve & Jeanne Keith: "Re: [MV] M151a2-Proper way to seal exhaust manifold"
• Next in thread: MVTrucker@aol.com: "Re: [MV] M151a2-Proper way to seal exhaust manifold"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Mike,
I strongly advise that you install a new exhaust manifold.
When I had the same problem as yours, I replaced the
manifold and used red high temp (for manifolds) silicone
sealer. This solved the problem. The manifold is tubular,
so I doubt that it could be resurfaced.
Joe Young

• Next message: tom-nooneofconsequence: "(no subject)"
• Previous message: tom-nooneofconsequence: "(no subject)"
• Maybe in reply to: Steve & Jeanne Keith: "Re: [MV] M151a2-Proper way to seal exhaust manifold"
• Next in thread: MVTrucker@aol.com: "Re: [MV] M151a2-Proper way to seal exhaust manifold"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Wed Apr 23 2003 - 13:25:35 PDT