From: Henry J. Fackovec (HFackovec@easternems.com)
Date: Sun Mar 02 2003 - 18:10:47 PST
If you are talking about the countersunk straight head screws, I used a
hammer driven impact driver to brake them loose and then a hand screwdriver
ina brace and bit to get them the rest of the way out.
Hankie
-----Original Message-----
From: Military Vehicles Mailing List [mailto:mil-veh@mil-veh.org]On
Behalf Of Buck & Rami Sharp
Sent: Sunday, March 02, 2003 8:37 PM
To: Military Vehicles Mailing List
Subject: [MV] armor extractor
what do i use to remove those armor plates on my half track?? a impact
driver ?what about the bits they would halft to be big wouldnt they ?im sure
someone will set me straight if it is a special tool does anyone have one or
two if they brake easily or know whare to get one? if there is different
ones which is the best one to get. thanks
-----
===Mil-Veh is a member-supported mailing list===
To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Wed Apr 23 2003 - 13:25:46 PDT