From: Fred Martin (mung@in-touch.net)
Date: Wed Mar 12 2003 - 11:46:06 PST
Probably cheaper to go to a hardware store and get a piece of 3/4"
keystock and make your own. Fred Martin
Beth wrote:
> Is there actually an easily available 3/4" square tool for the military
> diffs. I have a 2" breaker bar, but need the small square tool to get to
> one of the diff. plugs. I thought I would just go to a welding/steel type
> place and aske them to cut a 2 or 3" piece of 3/4" stock. Please advise.
> Tom "PM" C.
> 71 GG
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
This archive was generated by hypermail 2.1.4 : Wed Apr 23 2003 - 13:25:50 PDT