From: Steve & Jeanne Keith (cckw@attbi.com)
Date: Mon Apr 07 2003 - 14:11:39 PDT
Also important, you need the special Budd socket that automatically
selects the inner or outer nut to turn...
Steve AKA Dr Deuce
----- Original Message -----
From: "Ronzo" <rojoha@attbi.com>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Monday, April 07, 2003 4:00 PM
Subject: Re: [MV] 1" or 3/4" impact Wrench?
> 3/4" Harbor Freight impact works for me....
>
> ----- Original Message -----
> From: "Mark Ehle" <markehle@hotmail.com>
> To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
> Sent: Monday, April 07, 2003 3:18 PM
> Subject: [MV] 1" or 3/4" impact Wrench?
>
>
> > Folks -
> >
> > I have discovered that my wimpy 1/2" impact wrench does not have a
prayer
> > against my M35's wheel lug nuts.
> >
> > Do I need to get a 1" impact wrench, or will a 3/4" model do?
> >
> > Thanks -
> >
> > Mark Ehle
> >
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
>
This archive was generated by hypermail 2.1.4 : Wed Apr 23 2003 - 13:30:46 PDT