From: bobbyjoe@chartertn.net
Date: Wed Apr 09 2003 - 11:50:13 PDT
I almost bought a 24 volt impact wrench that connected into the slave
receptacle at the Vehicle show in Knob Creek KY a couple years ago, but the
seller would not let me hook it up to a 2 1/2 ton truck to see if it would
remove the lug nuts, so I did not buy it fearing it was not working or not
enough power to remove them.
BjP
----- Original Message -----
From: "Greg" <czechsix@cox.net>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Wednesday, 09 April, 2003 2:33 PM
Subject: Re: [MV] 1" or 3/4" impact Wrench?
> I'm sure somewhere GL will have them - I've seen some 24V 3/4" drive guns
> coming out from GL - I know IR makes a one inch model, but you really
don't
> want to know the price. Let's just say I could buy 2 deuces for one of
these
> wrenches. (it retails for about 2K)
>
> Greg
> Vista,CA
>
> RIP Mzirand
>
>
> ----- Original Message -----
> From: "Dave Jenkins" <gpw1942@bellatlantic.net>
> To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
> Sent: Wednesday, April 09, 2003 10:39 AM
> Subject: Re: [MV] 1" or 3/4" impact Wrench?
>
>
> > Any one know if they make an electric drive 1 inch impact gun. I have
been
> using
> > a 1/2 for a while and it works well.
> > Dj
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Wed Apr 23 2003 - 13:30:47 PDT