bridge plate location?

From: Bill & Bonnie Prestin (bprestin@chartermi.net)
Date: Fri Apr 18 2003 - 22:13:31 PDT

• Next message: Beth: "Re: [MV] Churchville/convoy: Should I put my 50 cal on the truck"
• Previous message: william f cox: "Re: [MV] M101A1 alternative rims and tires"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

    Does anyone know an approved location for the bridge plate on an M35
other than on the brush guard of the truck? I recently installed an
LDS-465-1A engine in my M35. I removed the bridge plate to try and reduce
any restriction of air flow through the radiator. I think I remember seeing
a truck with the plate on the fender once. Is this a proper location? If so,
which fender would be the correct one?

Bill

• Next message: Beth: "Re: [MV] Churchville/convoy: Should I put my 50 cal on the truck"
• Previous message: william f cox: "Re: [MV] M101A1 alternative rims and tires"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Wed Apr 23 2003 - 13:30:52 PDT