From: Joe Shannon (fordpart@bellsouth.net)
Date: Sat Apr 19 2003 - 04:57:26 PDT
When I got mine it was on the fender, mounted on a "L" bracket so it
would be standing up straight. David Doyle wrote an article about
bridge plates about 6 months back in MV mag.
Bill & Bonnie Prestin wrote:
> Does anyone know an approved location for the bridge plate on an M35
>other than on the brush guard of the truck? I recently installed an
>LDS-465-1A engine in my M35. I removed the bridge plate to try and reduce
>any restriction of air flow through the radiator. I think I remember seeing
>a truck with the plate on the fender once. Is this a proper location? If so,
>which fender would be the correct one?
>
>Bill
>
>
>
>===Mil-Veh is a member-supported mailing list===
>To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
>To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
>To reach a human, contact <ack@mil-veh.org>
>
>
>
This archive was generated by hypermail 2.1.4 : Wed Apr 23 2003 - 13:30:52 PDT