From: kuhrick (kuhrick@comcast.net)
Date: Sun May 18 2003 - 03:41:14 PDT
can you replace the sheet metal screws with mecin screws and luck nuts
you would need a box or open end wench in side the door to get them out
the screw or bolt would spin
ken
m886
kb9yku
At 05:58 PM 5/16/03 +0100, Michael Goodden wrote:
>Hi Joe
>
>Thanks for the info, I'll try and get some details.
>The problem with ones that just screw on from the outside, is that they
>can just be unscrewed and removed which kinda defeats the security!!
>The handles I've got need to be screwed on from the inside, which is
>where my problem arises!.... my solution at the moment is to drill a
>small hole in the side of the door and use a flexible screwdriver to fix
>them on... (otherwise its down to the welder!!)
>
>Many thanks
>Mike
>___________________
>Michael Goodden
>The Global Tipi Adventure
>http://TheTipi.com
>
>
>-----Original Message-----
>From: Military Vehicles Mailing List [mailto:mil-veh@mil-veh.org] On
>Behalf Of MVTrucker@aol.com
>Sent: 16 May 2003 17:04
>To: Military Vehicles Mailing List
>Subject: Re: [MV] M35 Locking Door Handles
>
>Mike,
>While I was at Churchville, a fellow at Exteme
>Off Road Equipment showed me a set of locking
>door handles for the M35 Series. They looked
>pretty good and he said that there's no mods
>required. Remove thw old handles and install
>the new, just two screws.
> www.extremeoffroadequipment.com
>Joe Young
>
>===Mil-Veh is a member-supported mailing list===
>To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
>To switch to the DIGEST mode, send e-mail to
><mil-veh-digest@mil-veh.org>
>To reach a human, contact <ack@mil-veh.org>
>
>
>
>===Mil-Veh is a member-supported mailing list===
>To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
>To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
>To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:20:31 PDT