From: Ronzo (rojoha@attbi.com)
Date: Tue May 20 2003 - 06:18:33 PDT
On my deuce I mounted a lighted license plate holder on the left tail light
bracket inboard of the tail light. Wired it in to the tail light using a
military wiring connecter kit, but weather proof 3M tap connectors would
also work, followed by a blast of flat black paint to mask the state
required MWO.
In my state, a front plate must also be displayed and the use of ty-wraps
on the grill is not an option. So, I drilled a couple of holes in the bumper
and there she be. If you whish, a piece of canvas could be put over it for
parades, or you could remove the plate.
Ron
----- Original Message -----
From: "D O" <dohe69@hotmail.com>
To: "Military Vehicles Mailing List" <mil-veh@mil-veh.org>
Sent: Monday, May 19, 2003 8:55 PM
Subject: [MV] Liscence plate mounting/location
> Stupid question, but where are you guys with deuces mounting your plates?
I
> have a van box, and don't want to put holes in it.
>
> _________________________________________________________________
> Tired of spam? Get advanced junk mail protection with MSN 8.
> http://join.msn.com/?page=features/junkmail
>
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:20:31 PDT