From: ECCM (eccm@swbell.net)
Date: Tue May 20 2003 - 17:17:21 PDT
Be sure to cut the mike gain or it will overload!
Michael Goodden wrote:
>
> Hi All
>
> Thanks for everyone's help and suggestions on the locking handles.
> Today I fitted the L shaped lever handles with the screws on the inside.
> The final solution was to cut a small rectangular hole in the side of
> the door which gave me access to screw up the internal screws.... very
> fiddly little job as I didn't want to make the hole any bigger than
> necessary. I've just got to make a little cover to fit over the hole.
>
> Now I have a nice secure truck!!! .... tomorrow I'll be embarking on the
> 6hr drive to pick up the workshop body.
>
> I also had a fascinating meeting with a soundproofing guy today, we've
> worked out some great ways to really cut out a lot of the sound and
> vibrations.... I'll record the sound prior to work and then the levels
> when its all done and report back to you all!
>
> Many thanks again
> Mike
> ___________________
> Michael Goodden
> The Global Tipi Adventure
> http://TheTipi.com
>
> ===Mil-Veh is a member-supported mailing list===
> To unsubscribe, send e-mail to: <mil-veh-off@mil-veh.org>
> To switch to the DIGEST mode, send e-mail to <mil-veh-digest@mil-veh.org>
> To reach a human, contact <ack@mil-veh.org>
This archive was generated by hypermail 2.1.4 : Sat May 07 2005 - 20:20:31 PDT